Poducts

  • EXPERIMENTAL INVESTIGATION ON PARTIAL REPLACEMENT OF

    replacing about 10%, 20%, 30% and 40% of steel slag aggregates by volume for M-sand will not do any harm to concrete and also it will not have any adverse effects on the strength and durability. Key Words: steel slag, partial replacement of fine aggregate 1. INTRODUCTION Steel Industries are growing widely nowadays. The

  • partial replacement of sand with steel slag

    Replacement of GGBS with cement 0% and replacement of steel slag with River sand 30%, similarly 5%, 10%, 15%, 20%, and 25% replacent of GGBS with cement and 30% steel slag replacement with sand. It was found to be compressive strength of concrete has greater strength when 15% GGBS replacement cement and 30% steel slag

  • Partial replacement of fine aggregate by steel slag and

    29/08/2020· The result shows that 40% replacement of steel slag with 20%of walnut shell gives better flexural strength for water curing to the 7 and 28 days. Also 50% replacement gives better compressive strength. But 40% replacement is desirable and economical replacement of steel slag as compare to fine aggregate. Also 10%, 20% and 30% replacement increases the strength as

  • replacement of sand with steel slag in concrete

    Owing to the scarcity and harmful of cement for the preparation of mortar and concrete, partial replacement of steel Slag with M-sand have been attempted. The effects of replacing cement by steel slag on the compression strength of cubes, split tensile strength of cylinders and textural strength of beams are evaluated in this study. steel slag is obtained as waste product from the sterlite

  • Replacement Of Sand By Steel Slag

    Partial replacement of sand with steel slag will be made for varying percentages such as 10, 20, 30, 40 and 50 of weight of sand.Studies on compressive strength, tensile strength, flexural strength and stress-strain curve will be made by experimental investigation and the. Usage Of Steel Slag In Concrete As Fine Andor Coarse . Containing steel slag under severe test conditions and found that

  • The effect of replacing sand by iron slag on physical

    01/12/2017· Fig. 3 presents the bulk density of cement mortars made of steel slag at percentages of 0%, 40%, 80% and 100% as a replacement for sand, submerged in water for 90 days. It was noted that, a marginal increase in the bulk density for all mixes was observed with increasing curing time up to 90 days. Mortar containing 40% of BOFS (M2) showed a steady increase in bulk density of

  • Cited by: 12
  • replacement of steel slag and quarry in concrete,

    The Exploitation of Blast furnace Slag as Sand . 2019-7-1 replacement of fine aggregate by steel slag improves the compressive, tensile and flexural strength of concrete. Compressive strength increased in large number when both CA and FA were replaced by steel slag.,Subathra and Gnanavel, [15]. Qasrawi et al, [16] used steel slag in concrete

  • Partial Replacement Of Fine Aggregate Using Steel Slag

    aggregates, steel slag of specific gravity 2.5 to 3.5 (2.36 mm to 4.75 mm) & potable water. With the help above materials the concrete of grade M 20 is prepared by varying the proportions of steel slag. In this study the sand is replaced by 0%, 10%, 20% & 30% by the steel slag. The various tests has been conducted to find out the engineering properties of harden concrete.

  • Utilization of Steel Slag in Concrete as a partial

    Kothai and Malathy [14] partially replace fine sand (SG=2.65) with fine steel slag (SG=2.95) in normal concrete and found increment of compressive strength at 5% to 10% when replacement level is

  • Strength Properties of Steel Slag in Concrete

    The aim of this experiment is to study the effect of Steel Slag as partial replacement of Fine Aggregate with 0%, 10%, 20%, 30%, and 40% are tested for M25& M30 grade of concrete after 7, 14, 28 and 50 days water curing. The result shows that variation in much strength for Fine aggregate replaced by Steel slag for 7, 14, 28 and 50 days water curing.

  • Cited by: 1
  • replacement of sand with steel slag in concrete

    Owing to the scarcity and harmful of cement for the preparation of mortar and concrete, partial replacement of steel Slag with M-sand have been attempted. The effects of replacing cement by steel slag on the compression strength of cubes, split tensile strength of cylinders and textural strength of beams are evaluated in this study. steel slag is obtained as waste product from the sterlite

  • Replacement Of Sand By Steel Slag

    Partial replacement of sand with steel slag will be made for varying percentages such as 10, 20, 30, 40 and 50 of weight of sand.Studies on compressive strength, tensile strength, flexural strength and stress-strain curve will be made by experimental investigation and the. Usage Of Steel Slag In Concrete As Fine Andor Coarse . Containing steel slag under severe test conditions and found that

  • Replacement Of Sand With Steel Slag In Concrete

    Replacement Of Sand With Steel Slag In Concrete. Of using iron slag as partial replacement of sand in concrete.Iron and steel making slag are by products of the iron making and steelmaking processes.To date, these types of slag have been widely used in cement and as aggregate for civil works.The report presents an investigation of. We are a large-scale joint-stock enterprise integrating

  • replacement of sand by steel slag

    Replacement Of Sand With Steel Slag In Concrete. With steel slag and fine aggregate with ecosand seems to be promising.In this study an attempt is made to use steel slag, a byproduct from steel industry as replacement for coarse aggregate in concrete and eco sand which is a commercial byproduct of cement manufacturing process introduced by Get Price. Replacement of Aggregates by Industrial

  • replacement of steel slag and quarry in concrete,

    The Exploitation of Blast furnace Slag as Sand . 2019-7-1 replacement of fine aggregate by steel slag improves the compressive, tensile and flexural strength of concrete. Compressive strength increased in large number when both CA and FA were replaced by steel slag.,Subathra and Gnanavel, [15]. Qasrawi et al, [16] used steel slag in concrete

  • Strength Properties of Steel Slag in Concrete

    Aggregate with Steel Slag at different Properties”. The aim of this experiment is to study the effect of partial replacement of steel slag on various strength and durability properties of concrete by using mix design. The test is carried out at the replacement level of 10%, 20%, 30%, 40% at the ages of 7 and

  • Experimental Investigation on Concrete by Replacement of

    that up to 50% of steel slag can be used as replacement of sand. The utilization of steel slag in concrete provides additional environmental as well as technical benefits for all related industries. Replacement of steel slag increases the self weight of concrete specimens to the maximum of 15 to 20 %.For higher replacement of steel slag in sand

  • The Exploitation of Blast furnace Slag as Sand Replacement

    strength is improved when the steel slag is used for low sand replacement ratios (up to 30%). When optimum values are used, the 28-day tensile strength of concrete is improved by 1.4–2.4 times and the compressive strength is improved by 1.1–1.3 times depending on the replacement ratio and the grade of concrete. The best results are obtained for replacement ratios of 30–50% for tensile

  • copper slag as sand replacement on hpc

    replacement of fine aggregate with copper slag for . copper slag as sand replacement on hpc. using copper slag as a replacement of fine aggregate on the strength properti M25 grade concrete was used and tests were conducted for various proportions of copper slag replacement with sand of 0 to in concrete The test results indicate that compressive strength of concrete Chat Online copper slag mill

  • EXPERIMENTAL INVESTIGATIONS ON PARTIAL REPLACEMENT OF

    REPLACEMENT OF STEEL SLAG AS COARSE AGGREGATES AND ECO SAND AS FINE AGGREGATE Nandini Suri P.G Student, Civil Engineering Department, MVR College of Engineering and Technology, Paritala, Andhra Pradesh, India Y. Anandh Babu, Ph.D HOD, Civil Engineering Department, MVR College of Engineering and Technology, Paritala, Andhra Pradesh, India ABSTRACT Concrete

  • Replacement Of Sand By Steel Slag In Concrete

    Replacement Of Sand With Steel Slag In Concrete. Use of iron slag as partial replacement of sand to concretelag is one of the industrial by-product from the iron and steel making industri in this paper, the compressive strength of the iron slag concrete was studied the results confirm that the use of iron slag overcome the pollution problems in the environment the results shows that the iron

  • EFFECT OF PARTIAL REPLACEMENT OF SAND BY IRON SLAG ON

    of using iron slag as partial replacement of sand in concrete. Iron and steel making slag are by products of the iron making and steelmaking processes. To date, these types of slag have been widely used in cement and as aggregate for civil works. The report presents an investigation of mechanical and durability properties of concrete by adding iron slag as replacement of sand in various

  • EXPERIMENTAL INVESTIGATIONS ON PARTIAL REPLACEMENT OF

    REPLACEMENT OF STEEL SLAG AS COARSE AGGREGATES AND ECO SAND AS FINE AGGREGATE Nandini Suri P.G Student, Civil Engineering Department, MVR College of Engineering and Technology, Paritala, Andhra Pradesh, India Y. Anandh Babu, Ph.D HOD, Civil Engineering Department, MVR College of Engineering and Technology, Paritala, Andhra Pradesh, India ABSTRACT Concrete

  • experimental investigation on steel slag and mill scale in

    The experimental results show the application of steel slag sand may reduce the dosage of cement clinker and increase the content of industrial waste product using steel slag sand. Isa Yuksel, Omer Ozkan, Turhan Bilir, 2006 [2] experimented use of non ground granulated blast furnace slag as fine aggregate in concrete.

  • copper slag as sand replacement on hpc

    replacement of fine aggregate with copper slag for . copper slag as sand replacement on hpc. using copper slag as a replacement of fine aggregate on the strength properti M25 grade concrete was used and tests were conducted for various proportions of copper slag replacement with sand of 0 to in concrete The test results indicate that compressive strength of concrete Chat Online copper slag mill

  • Replacement of Sand with Bauxite Mining Waste in

    - A.S. Gaur, S. Kumar, Effect of Partial Replacement of Cement by Ground-Granulated Blast-Furnace Slag and Fine Aggregate by Marble Slurry on Properties of Concrete. Am. J. Eng. Res. 6(1) (2017) 28-31. I. Mpae, Utilization of Bauxite Tailings as partial replacement of sand in blocks, MPhil Thesis, University of Education, Winneba, 2014.

  • Slag sand a good alternative to river sand, say experts

    17/03/2015· Microscopically, river sand and Granulated Blast Furnace Slag Sand are similar, Mr. Kunte said, adding that once discarded by-product is now specified for. The PWD had also ordered the use of slag

  • Copper Slag As Sand Replacement In Zambia

    Copper Slag As Sand Replacement In Zambia. March 25, 2015 2015018332 in the photo, Heishan is a copper slag heap, located in the town of Kitwe wusakile. Slag is a kind of waste left over from the extraction of metal from ores. It is used in road and railway subgrade construction after mixing with cement. It can also be used for sandblasting of roof tiles and many other purposes . Send Message

  • Experimental Investigation on Partial Replacement of

    natural river sand as a partial replacement and waste limestone aggregates has been used in place of Coarse aggregates (Basalt stones) as the partial replacement. Steel Slag is the waste by-product obtained from the iron and steel plants and Waste Limestone Aggregates are obtained from the Limestone quarries. Good strength is expected with . Experimental Investigation on Partial Replacement

  • EXPERIMENTAL STUDY ON PARTIAL REPLACEMENT OF STEEL SLAG

    utilization it as replacement of natural sand. Steel Slag is produced locally in great amount which leads in causing many environmental problems alike natural depletion when disposed. To over-come this issue, slag is the sound choice in favor of ecology being used as fine aggregate in rapid concrete sector. This work includes the determination of different properties of locally available steel